Breeder Chicken Equipments
H type Layer/Broiler Breeder Rearing Equipment is the professional H Frame Cage System for layer or broiler breeding chickens with manure removal belt.it is designed to be used for Nature Mating of Male and Female chickens in the cages.there is no grids in every set of cages,therefore the breeding chickens can move without limitation.thus,they will get more comfortable living space which can give them more vitality.the breeding chickens can improve their mating rate and egg laying rate.meanwhile,the breeding eggs with higher vitality means higher incubation rate and more healthy baby chickens.
1. The front part of cages is fixed by grid, composed of vertical grille, guaranteed that the male chickens has the optimal feeding conditions, and prevent the comb hurt,another part is sliding grid, it can fully open and convenient to operate such as getting chickens inside and outside, the grid is separated in level, it provides appropriate conditions to the feed of the male and female chickens,they can choose the distribution of grille freely.
2. The cages designed without cage meshes on top in case of hurting on male chickens while mating,because male chickens is bigger than the female chickens.
3. Each cage are separated by the closed partition board which made of hot galvanized steel sheets with thickness 1.0mm, it ensures the chicken between different groups is completely isolated, and keep peaceful and quiet space for chickens.meanwhile,the partition board with holes also supply enough ventilation to the chicken house.
4. Nipple pipe located at both sides of the cages, we can install different height of nipple pipe for the cock and the hen, nipples are made of stainless steel.the water pipe are square PVC ones with dimension 25*25mm,thickness 2.50mm,equipped with Water Pressure Regulators,Terminals and Water Filters,Dosers(from DOSATRON).
5. The chain convey feed to front of chicken evenly and smoothly,, each feeding circuit has a driver, no additional transmission components, deep feed trough avoid waste of feed
6.The bottom mesh is placed on tight wire, the steel wire is tight in the whole length system, it ensure the elasticity of steel wire, thereby it drop the ratio of broken egg and cracked egg to the lowest, there have different mesh size at the bottom of mesh, 1X1 inch make the cock and the hen stand more stable, the mesh size of feeding area: 1 x1.5 inches , it is more conducive to store eggs, and the eggs fell to longitudinal conveyor belt, which means high hatching rate and good quality of egg shell.
7. Perched device: there have perched unit in the middle of the cages , it is easy to be accepted by the cock and the hen, as the matching.
